1. Using the sharpie trace the guitar pick onto the CD. repeat until you can't pu any more on the CD

2. cut out the picks

3. sand off the design on front and sand the back to add roughness

4. Smooth the sides using the nail/wire file

5. Paint one side of the pick using the enamel paint.

6. when it is dry paint other side
7. using the nail and hammer carefully put two holes in the pick (or one hole if you want it to hang on a jump ring). The pick will break if you hammer just wrong so you should have made a few extra picks.

8.tie the coated wire in half so there are 2 strands
9. slip a bead on both strands.
10. put one strand up though the first hole of the pick and down the other hole
11. put the other strand down though the first hole and up through the other hole.
12. Repeat steps 9-11 until you have reached the desired length. then tie off.